|
Product Information Device Database® Evaluation Software Compliance Testing Distributors | NXP (founded by Philips) P87LPC760The NXP (founded by Philips) P87LPC760 is an 8051 based CMOS controller with 12 I/O lines, 2 Timers/Counters, 4 Interrupt Priority Levels, 2 Analog comp, Dual DPTR, I2C-Bus, 2K Byte on-chip programable EPROM, 128 Bytes on-chip RAM.
Data Sheets 
|
| Development Tools
Compiler, Assembler, Linker, Debugger |
Simulated Features NOTE
Simulation for this device is provided by the default peripheral simulation driver.
Complete peripheral simulation is not available at this time. |
The following on-chip peripherals are simulated by the Keil Software µVision Debugger. - Analog Comparator
- Brownout Detection
- CPU Clock Output
- I²C Interface
- Interrupts 12S/4L (Including External)
- Keyboard Interrupt
- Oscillator Control
- Port 0 (Quasi-bidirectional, Push-Pull, Input Only, Open Drain)
- Port 1 (Quasi-bidirectional, Push-Pull, Input Only, Open Drain)
- Port 2 (Quasi-bidirectional, Push-Pull, Input Only, Open Drain, 2-bits)
- Power Saving Modes (Idle and Power Down)
- Power-On Detection
- Serial UART (Enhanced Interface)
- Software Reset (SRST Bit)
- System Configuration Byte UCFG1
- Timer 0 (Standard Timer + Pin Toggle)
- Timer 1 (Standard Timer + Pin Toggle)
- Watchdog Timer
|
AGSI Drivers The following AGSI Drivers are available for the Keil Software µVision Simulator. |
AGDI Drivers The following AGDI Drivers are available for the Keil Software µVision Debugger. |
Consultants The following consultants have experience with this device. |
|
|
|
