Peripheral Simulation

For Infineon C166 (all Variants) — Timer Block GPT2 (T5, T6) Without Input and Direction Pins

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Timer/Counter 5 Dialog

The Timer/Counter 5 dialog allows you to view and change the SFRs associated with Timer/Counter 5. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

• Mode contains the operating mode and the input selector for the timer.
• T5UD is the timer up/down control.
• Direction displays whether the timer/counter counts up or down.
• Capture selects the mode of the capture trigger.
• T5SC enables or disables capture into the CAPREL SFR.
• CAPIN contains the state of the CAPIN pin of the MCU.
• CRIR is the Interrupt Request flag for the CAPREL (Capture/Reload) SFR.
• CAPREL is the value of the Capture/Reload SFR.
• T5CLR specifies whether or not Timer 5 is cleared on a capture.
• Status displays the current status of the timer.
• T5 contains the value of the T5 SFR which is the current timer value or count.
• T5CON contains the value of the T5CON SFR which is the current configuration for timer 5.
• T5R is the Timer 5 Run flag.
• T5IR is the Timer 5 Interrupt Request flag.

Timer/Counter 6 Dialog

The Timer/Counter 6 dialog allows you to view and change the SFRs associated with Timer/Counter 6. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

• Mode contains the operating mode and the input selector for the timer.
• T6UD is the timer up/down control.
• Direction displays whether the timer/counter counts up or down.
• T6OTL is the output toggle latch flag.
• T6OE is the timer output enable flag.
• T6OUT is the state of the T6OUT output pin.
• Status displays the current status of the timer.
• CAPREL is the value of the Capture/Reload SFR.
• T6 contains the value of the T6 SFR which is the current timer value or count.
• T6CON contains the value of the T6CON SFR which is the current configuration for timer 6.
• T6R is the Timer 6 Run flag.
• T6SR is the Timer 6 Reload Mode Enable flag.
• T6IR is the Timer 6 Interrupt Request flag.
• CRIR is the Interrupt Request flag for the CAPREL (Capture/Reload) SFR.