ULINK: DEBUG IN OFF-CHIP FLASH OF PHILIPS LPC22XX

Information in this article applies to:

• Keil Development Suite for ARM V2.0 or higher
• ULINK USB-JTAG Adapter
• ULINK2 USB-JTAG Adapter

QUESTION

I have problems debugging an application that is stored in off-chip FLASH ROM. What must I do to debug my program?

ANSWER

The ULINK USB-JTAG Adapter uses the BOOT0 (P2.26) and BOOT1 (P2.27) pins to determine the startup configuration. When these pins are both set to 1, the µVision Debugger starts the program in the off-chip Flash ROM.

You may manually override the settings of the BOOTx pins using the following Debugger initialization file (*.INI file) that you must specify under Project — Options — Debug — ULINK ARM Debugger — Initialization File:

  _WDWORD(0xFFE00000, 0x20003CE3);   // BCFG0: Flash Bus Configuration (32-bit)
  _WDWORD(0xE002C014, 0x0E6001E4);   // PINSEL2: CS0, OE, WE, BLS0..3, D0..31, A2..23, JTAG

  _WDWORD(0xE01FC040, 0x00000003);   // MEMMAP: Memory Mapping
  LOAD AppFile INCREMENTAL
  g, main

Note that you must disable the Load application at Startup option in the dialog Project — Options — Debug — ULINK ARM Debugger.

MORE INFORMATION

• Getting Started User's Guide, JTAG Debugging
• Refer to Start Sequence in the ULINK® User's Guide.

SEE ALSO

• ARM: MEMORY MISMATCH ERRORS DURING LOAD
• ULINK: RESET BEHAVIOUR ON PHILIPS LPC2000 DEVICES
• ULINK: HOW TO SET THE ULINK VCC JUMPER
• ULINK: NO ALGORITHM FOUND FOR ADDRESS
• ULINK: ARM SUPPORTS ONLY TWO BREAKS IN FLASH ROM
• ARM: DEBUG PROGRAMS IN ON-CHIP RAM OF PHILIPS LPC2000

Last Reviewed: Sunday, January 28, 2007